Which north? True, magnetic and grid north on a map
Many people believe that a compass needle points at the North Magnetic Pole. Natural Resources Canada says this is not true. If you followed your needle you would eventually arrive at the pole, but not by the most direct route. A compass lines up with the local magnetic field, and that field has a complicated shape.
So the word “north” on a map can mean three different directions: the direction to the geographic pole, the direction a compass points, and the direction of the map's own grid lines. They usually differ by some degrees, and one of them keeps drifting. Knowing which north a map or a bearing refers to is what separates a correct heading from a slow wander off course.
The three norths and what defines each one
True north, also called geographic or geodetic north, is the direction along a meridian toward the geographic North Pole, where all lines of longitude converge. On USGS topographic maps, a star marks it, and it is the direction of the line of longitude that bisects the map. Magnetic north is the direction a compass needle points at your location. The USGS notes that it varies over time and with position on the Earth, so the value printed on an old map may no longer be right.
Grid north is the direction of the vertical lines of the grid drawn on a flat map. On current USGS maps the grid is the Universal Transverse Mercator grid, and the difference between grid north and true north is a built-in effect of flattening the globe. As Ordnance Survey explains, grid north depends on the projection and often differs from true north by a couple of degrees. The flattening itself is the subject of map projections.
| North | What defines it | Does it change with time? | Mark on a USGS map |
|---|---|---|---|
| True north | Direction toward the geographic North Pole along a meridian | No | Star |
| Magnetic north | Direction a compass needle points at your location | Yes, slowly and unevenly | MN |
| Grid north | Direction of the vertical lines of the map grid after projection | No, it is fixed by the map's grid | GN |
How magnetic declination works and why it keeps changing
The angle between magnetic north and true north is the magnetic declination. Land navigators use that term, while mariners and pilots usually say variation. A third word, deviation, means something else: the error that iron in a ship or aircraft adds to its own compass. A declination marked W means magnetic north lies west of true north, and E means it lies to the east.
Declination depends on where you stand and when. NOAA's National Centers for Environmental Information states that it changes with location and time, which is why a geomagnetic model is used to correct for it. The model, the World Magnetic Model, is updated every five years, and as of 2026 the current version is valid until late 2029. Natural Resources Canada adds that the rate of change varies sharply between places: in some locations it is large, in others it is almost zero. Close to the North Magnetic Pole, declination changes become increasingly irregular because the horizontal part of the field grows weak there.
The declination diagram on a topographic map needs one more distinction. According to Natural Resources Canada, the angle printed there is between magnetic north and grid north, called the grid declination. The angle between grid north and true north is the convergence angle. To get the true declination, you combine the two.
How maps show direction, and when north is not at the top
The orientation of a map is the compass direction toward the top of the page. Modern maps generally put north at the top, and Ordnance Survey notes that readers of large-scale maps assume this unless told otherwise. If the top is not north, a north arrow is essential. When only one arrow is drawn, it normally points north, as National Geographic Education points out.
On small-scale maps, from a country to the whole world, one arrow can mislead. Because meridians are not parallel on many projections, the direction of north varies across the sheet, and an arrow is right only along one line. Ordnance Survey recommends a graticule of latitude and longitude lines in such cases, which works because latitude and longitude form the same grid on every map. Atlases face this problem on every page, as noted in how to read an atlas.
- Find the declination diagram or the note in the margin, and read the year it was published.
- Decide which north your task needs: true for geographic bearings, grid for lines drawn on the map, magnetic for a compass.
- Get the current declination for your location from a geomagnetic model calculator rather than relying on an old figure.
- Check whether the diagram shows W or E and apply the correction in the matching direction.
- Keep the compass away from iron, steel and electronics that can disturb the needle.
Common mistakes with north and orientation
- Believing the needle points at the magnetic pole
A compass follows the local magnetic field, so its needle rarely points straight at the pole. Do not use it as a pointer to the pole's position.
- Using the declination of an old map without updating
The USGS warns that declination values on old maps might no longer be accurate. Check the publication year and recalculate with a current model.
- Applying the correction in the wrong direction
Read whether the diagram says W or E, then check the arrow positions. Adding when you should subtract doubles the error instead of removing it.
- Mixing up grid north and true north
The two differ by an amount that depends on the projection and the position on the map. Use the diagram's marked angle, not an assumption.
- Trusting one north arrow on a map of a continent
On small-scale maps, the direction of north changes across the sheet. The arrow is right in one place only, and the lines of latitude and longitude are the safer guide.
Frequently asked questions
What is the difference between true north and magnetic north?
True north is the direction toward the geographic North Pole along a meridian. Magnetic north is the direction a compass needle points at your location. The angle between them is the magnetic declination, and it varies with place and time.
What is magnetic declination?
It is the angle between magnetic north and true north at a given place and date. Land navigators call it declination, while mariners and pilots often call it variation.
Does magnetic declination change over time?
Yes. NOAA says it changes with location and time. For that reason the World Magnetic Model is renewed every five years, and printed values go out of date.
What is grid north?
It is the direction of the vertical lines of the grid on a flat map, set by the projection. On current USGS topographic maps, the grid is the Universal Transverse Mercator grid. Grid north and true north differ slightly, and the diagram in the margin shows by how much.
How do I find the current declination for a place?
Use an online declination calculator that runs on a geomagnetic model, such as the one provided by NOAA. Enter the coordinates and the date. A map's printed value is correct only for its publication year, unless updated.
Sources
- What do the different north arrows on a USGS topographic map mean? U.S. Geological Survey
- Magnetic declination Natural Resources Canada, Geomagnetism
- World Magnetic Model NOAA National Centers for Environmental Information
- North arrows (More than Maps: guide to cartography) Ordnance Survey
- Maps National Geographic Education
- Map Wikipedia