Relief, climate and landscapes
Flat, high or low? Telling plains, plateaus and valleys apart on a map
Elevation alone does not name a landform. The National Geographic Society says abyssal plains, which lie on the ocean floor, sit 5,000 to 7,000 meters below sea level, and they are still plains. The U.S. Geological Survey (USGS) gives the Tibetan Plateau an average elevation of about 4,600 meters, and that is a plateau. Both are flat. What separates them is where they sit compared with the ground around them.
That comparison is the key to reading relief on a map. National Geographic lists plains and plateaus, with mountains and hills, as the four major landforms. Valleys are the low ground carved between higher land. Below, each landform gets a working definition, a short account of how it forms, and the map clues that let you tell them apart.
What sets a plain, a plateau and a valley apart
National Geographic defines a plain as a broad area of relatively flat land. Plains cover more than one-third of the world's land area and exist on every continent. A plateau is a flat, elevated landform with a steep rise above the surrounding area on at least one side, and it covers about a third of Earth's land. A valley is low ground between higher ground, and its shape records what carved it.
| Landform | Defining trait | Typical origin | Example |
|---|---|---|---|
| Plain | Broad and relatively flat, with low relief | Sediment laid down by water or ice; lava spreading across land | Great Plains of central North America; Atlantic Coastal Plain |
| Plateau | Flat top, raised, with a steep rise on at least one side | Crust pushed upward, or layers of lava built up over time | Colorado Plateau; North Island Volcanic Plateau |
| Valley | Low ground between higher ground | Rivers cutting downward, or glaciers scouring a valley | Grand Canyon, cut by the Colorado River |
The categories overlap in practice. A plateau can hold a plain on its top, and a plain can be cut by many shallow valleys. Treat the definitions as a guide to what dominates a landscape, not as rigid boxes.
How plains and plateaus form
National Geographic describes several routes to a plain. Ice and water wear down higher land and carry sediment downhill, and layers of that sediment build up. Rivers widen valleys over time and flood, depositing sediment on flood plains. Where sediment-laden water spreads out at the foot of mountains it makes an alluvial plain, and where rivers build land along a coast they make a coastal plain. Lava spreading across the land can also make a lava plain. The article on rivers and drainage basins shows how the water that builds flood plains is collected.
Plateaus form by two main routes, according to National Geographic. In dissected plateaus the crust moves upward, often from the slow collision of tectonic plates, and erosion then cuts into the raised surface. In volcanic plateaus many small eruptions build up layers of lava. The Colorado Plateau shows the first route. The National Park Service (NPS) says plate tectonics lifted the region into a high plateau without significantly deforming its rock layers, with uplift between 70 and 30 million years ago, and that the Colorado River began carving its way downward just 5 to 6 million years ago. The uplift process is explained in how mountain ranges form, and lava landscapes in volcanoes and the Ring of Fire.
Valleys: the V shapes and the U shapes
The NPS defines downcutting as the process in which a river carves out a canyon or valley, cutting down into the earth and eroding away rock. Rivers and streams typically leave V-shaped valleys. The Grand Canyon is a large example, carved into the Colorado Plateau after it was lifted.
Glaciers leave a different mark. A USGS classroom activity contrasts U-shaped glacial valleys with the smaller V-shaped valleys carved by rivers and streams. On a topographic map, its answer key says, glacial valleys show a U shape pointing upstream and river valleys show a V shape, also pointing upstream. Ridges follow the opposite rule: ridge V's point downstream, and rivers run in valley bottoms, not along ridge tops.
Reading landforms with contour lines
The USGS explains that each contour is a line of equal elevation, so contours never cross. Contours that are very close together represent steep slopes, and widely spaced contours or an absence of contours mean the ground is relatively level. The contour interval is printed in the margin of each USGS map, and the USGS says maps of flat areas may use an interval of 10 feet or less, while maps of mountainous areas may use 100 feet or more. Always read the interval before comparing two maps. The method is covered in contour lines and elevation, and the arithmetic of distance in map scale explained.
- What is the contour interval, and what is the map scale?
- Are the contours widely spaced or missing across a large area? That points to a plain or a plateau top.
- Is that flat area higher than its surroundings, with a band of tightly packed contours on at least one side? That points to a plateau.
- Do contours bend into V or U shapes that point toward higher ground? That marks a valley.
- Does a stream run along the bottom of the V, and does a flattened U suggest a glacier?
- On a shaded map, does the legend explain which colors stand for low and high ground?
Shaded and colored relief maps rely on legends, so the guidance in map symbols and legends applies, and a physical map tends to show these landforms better than a political one, as political vs physical maps explains. If you note the landform type of places you have visited in the travel map editor, you build a record that is easy to search later.
Common mistakes about plains, plateaus and valleys
- Calling any high place a plateau
A plateau needs a flat top and a steep rise on at least one side. High ground that is rugged or has no steep edge is better described as a highland or a mountain area.
- Assuming a plain must be low
Flatness defines a plain, not height. National Geographic describes abyssal plains 5,000 to 7,000 meters below sea level, and the same word covers lowland plains on land.
- Reading wide contour spacing as low ground
Spacing shows slope, not height. Widely spaced contours mean relatively level ground at any elevation, so check the elevation labels on the bold lines.
- Treating every valley as V-shaped
Rivers cut V-shaped valleys, while glaciers leave U-shaped ones with broad floors. The contour shape on a map tells you which process was at work.
- Comparing maps without checking the contour interval
The USGS notes that the interval varies: 10 feet or less on maps of flat areas and 100 feet or more in mountainous areas. The same slope looks different at different intervals.
Frequently asked questions
What is the difference between a plateau and a plain?
Both have flat surfaces. A plain is a broad flat area at any elevation, while a plateau is flat and raised, with a steep rise above the surrounding land on at least one side.
How does a plateau form?
National Geographic describes two routes. Crust can be pushed upward, often by tectonic plate collision, and then be dissected by erosion. Or many small eruptions can pile up layers of lava into a volcanic plateau.
How do you recognize a valley on a contour map?
Look for contour lines that bend into V shapes, or flattened U shapes for glacial valleys. According to the USGS, valley V's point upstream and ridge V's point downstream, and streams run along the valley bottom.
What is the largest plateau in the world?
National Geographic calls the Tibetan Plateau the largest plateau in the world, covering about 2.5 million square kilometers. The USGS gives it an average elevation of about 4,600 meters.
Why do some plateaus have deep canyons?
Once a plateau is lifted, rivers cut downward into it. The NPS says the Colorado Plateau was uplifted between 70 and 30 million years ago, and that the Colorado River began carving the Grand Canyon 5 to 6 million years ago.
Sources
- Plain National Geographic Society, Education
- Plateau National Geographic Society, Education
- Topographic Map Symbols U.S. Geological Survey
- Play-Dough Topo (Living with a Volcano in Your Backyard, GIP 19) U.S. Geological Survey
- Geology - Grand Canyon National Park U.S. National Park Service
- Understanding plate motions [This Dynamic Earth] U.S. Geological Survey