Relief, climate and landscapes

Why does the date change in mid-ocean? Time zones, UTC and the date line

Abstract illustration of contour lines in amber tones, like a relief map

In the IANA Time Zone Database, the clocks of Samoa jump from the end of 29 December 2011 to 31 December 2011. The standard offset changes from UTC−11 to UTC+13, and 30 December never happens there. Nothing physical happened. Samoa moved from one side of the International Date Line to the other, and the calendar followed.

That small case shows what a time zone really is. It is not a strip of land or sea cut by nature. It is a clock setting that a place agrees on, usually by law, and that other places must be able to convert. The sections below start from the shared reference, then show the zones that break the whole-hour pattern and the line where the date changes.

UTC, the reference every zone points to

Coordinated Universal Time (UTC) is the shared reference for civil time. The International Bureau of Weights and Measures (BIPM) computes it from clock and time-transfer data contributed by around 80 time laboratories worldwide, using approximately 450 atomic clocks. The BIPM first computes International Atomic Time (TAI), a continuous atomic time scale, and then derives UTC from it. Leap seconds are added to keep UTC in agreement with time based on the rotation of the Earth.

UTC replaced Greenwich Mean Time (GMT) as the international standard. Royal Museums Greenwich says GMT was that standard from 1884 until 1972, after the Greenwich meridian was recommended as the prime meridian of the world, the line of 0° longitude. Local clocks are written as offsets from UTC, such as UTC+5:45 or UTC−3:30. The idea behind the offsets is simple geometry. Earth turns 360° in 24 hours, so the sun appears to cross 15° of longitude each hour. In practice, each place picks its own offset, and the choice often follows borders and law instead of the 15° strips. The coordinates that locate a place are explained in latitude and longitude coordinates.

Zones that are not a whole hour away

Whole-hour offsets are common, but not universal. The IANA Time Zone Database, which software uses to convert times, records several standard offsets with a 30 or 45 minute remainder. It also records the two extremes: a zone at UTC+14 and a notional zone at UTC−12, which are 26 hours apart.

Standard time offsets from UTC in selected IANA zones
IANA zoneStandard offsetPlace
America/St_JohnsUTC−3:30Newfoundland, Canada
Pacific/MarquesasUTC−9:30Marquesas Islands, French Polynesia
Asia/KolkataUTC+5:30India
Asia/KathmanduUTC+5:45Nepal
Australia/EuclaUTC+8:45A small area of Western Australia
Australia/AdelaideUTC+9:30South Australia
Pacific/ChathamUTC+12:45Chatham Islands, New Zealand
Pacific/KiritimatiUTC+14Line Islands, Kiribati

Daylight saving time adds another layer. Some places move their clocks by an hour for part of the year, and others do not. IANA's design notes say that whether and when a zone changes its clock, and even its base offset from UTC, are variable, and that predictions will be wrong after governments change the rules. Any list of daylight saving dates can therefore go out of date. We do not take a view on whether clocks should change; we only note that the rules belong to each place and can change.

How the International Date Line works

The U.S. National Oceanic and Atmospheric Administration (NOAA) describes the International Date Line as the line of demarcation between two consecutive calendar dates. It runs through the mid-Pacific Ocean, roughly following 180° longitude, halfway around the globe from the prime meridian. Crossing it westward moves you forward one calendar day, and crossing back eastward returns you to the earlier date.

The line is not straight. It generally runs from pole to pole but bends around political borders, such as eastern Russia and the Aleutian Islands of Alaska, and NOAA says it has no legal international status, so each country decides which date it observes. IANA's data shows how this works in practice. Pacific/Kiritimati moved from UTC−10 to UTC+14 at the end of 1994, and Pacific/Apia moved from UTC−11 to UTC+13 at the end of 29 December 2011. In both cases a place changed sides, and the line on maps changed with it. Where the line falls on a world map also depends on the map's center, a point covered in map projections explained.

Working with times across zones

Habits that prevent time-zone errors
  • Write times with a UTC offset, such as 17:45 UTC+5:45, not only a city or a zone abbreviation.
  • Check whether the place uses daylight saving, and on which dates, in a current source.
  • Convert through UTC first, then to the second place; this avoids mixing two local rules.
  • After a westward crossing of the date line, add a day; after an eastward crossing, subtract one.
  • For software, use IANA names such as Asia/Kathmandu, which follow the database as rules change.
  • Keep the local date and the home date apart in notes, because they can differ by a day.

East and west also frame the whole system. The meridians that split the globe, and the halves they define, are described in hemispheres explained. If you keep a record of the places you have been in the travel map editor, noting the local date next to each pin helps when a trip crossed the line.

Common mistakes about time zones

  • Assuming zones are neat 15° strips

    The 15° rule explains the idea, but real zones follow borders and local law. IANA's notes say governments can change zone rules, so a map of strips is only a starting point.

  • Treating UTC and GMT as the same thing

    GMT was the international standard from 1884 to 1972 and is based on the Greenwich meridian. UTC is produced by the BIPM from atomic clocks. The two are close in everyday use, but they are different scales.

  • Expecting every zone to be a whole hour from UTC

    Offsets such as UTC+5:30, UTC+5:45 and UTC+12:45 exist in the IANA database. Software that rounds offsets to whole hours gives wrong times for these places.

  • Drawing the date line as a straight legal border

    NOAA says the line roughly follows 180° longitude and has no legal international status. It bends around borders, and a country can move across it.

  • Hard-coding daylight saving dates

    Governments set the dates and can change them, and IANA updates its data to follow. Look up current rules instead of trusting last year's schedule.

  • Confusing time zones with climate zones

    A time zone is a clock rule. A climate zone describes temperature and rainfall, as in the Köppen climate zones. The two grids do not match.

Frequently asked questions

What is UTC?

UTC is Coordinated Universal Time, the reference that local times are measured from. The BIPM computes it from data supplied by around 80 time laboratories, and leap seconds keep it in agreement with the rotation of the Earth.

Which time zones are off by 30 or 45 minutes?

In the IANA database, India uses UTC+5:30, Nepal UTC+5:45, South Australia UTC+9:30 and the Chatham Islands UTC+12:45 in standard time. Newfoundland uses UTC−3:30 and the Marquesas Islands UTC−9:30.

Where is the International Date Line?

It runs through the mid-Pacific Ocean and roughly follows 180° longitude, halfway around the globe from the prime meridian at Greenwich. It bends around some borders, so its exact path follows local law.

What happens to the date when you cross the line?

According to NOAA, crossing westward moves you forward one calendar day, and crossing back eastward returns you to the earlier date. The change applies to the calendar date, and the clock time is whatever the zone you enter shows.

Can a place change its side of the date line?

Yes. IANA's data shows Pacific/Kiritimati changing to UTC+14 in the 1990s and Pacific/Apia changing from UTC−11 to UTC+13 in December 2011. Because the line has no legal international status, each country decides which date it observes.

Sources

  1. Time Zone Database IANA (Internet Assigned Numbers Authority)
  2. Theory and pragmatics of the tz code and data IANA Time Zone Database project
  3. Time Zone Database source files (asia, australasia, northamerica, etcetera) IANA
  4. Coordinated Universal Time (UTC) BIPM (International Bureau of Weights and Measures)
  5. What is the international date line? NOAA National Ocean Service
  6. What is Greenwich Mean Time (GMT) - and why does it matter? Royal Museums Greenwich

Keep a record of the places you have been, and see what share of the world you have covered.

Open the travel map editor